top of page

Support page for
of SXM 6.3L cases


On this page you will find all the necessary information for assembling a computer in our case SXM 6.3L. Assembly in small cases can be difficult due to the compact arrangement of components. Our tips will help you assemble a computer quickly and correctly. Just follow our tips and recommendations.


Assembling a computer requires certain knowledge and skills! If you do not have sufficient experience and knowledge of assembly, you can contact us.

  1. Preparation. 

    Make sure your assembly components match the case specifications.

    Remove the covers and the front panel by unscrewing the screws. 


  2. Installation of the Power Supply Unit (PSU).

    The case supports installation of SFX or SFX-L format PSU.  Install the PSU into the case and fasten with screws. 


  3. Installation of the casing fan.

    Skip this step if you do not plan to install a fan.
    The case supports the installation of slim fans 120mm to 17mm thick, for example, Noctua NF-A12x15.

    We recommend installing the fan with the air flow direction upwards. Fasten the fan with two screws.


  4. Installing a video card.

    Skip this step if you don't plan to use a graphics card.

    Mini-ITX video cards with a thickness of no more than 44 mm and a length of up to 183 mm can be installed in this case.

    Unscrew the outer corner of the fastener from the case, as well as the bar inside the case on which the riser cable is fixed. Attach riser cable to the video card. Install the video card in the case by winding it riser  the cable to the side of the motherboard and fasten with screws, and also fasten the outer corner to the video card blank.


  5. Installation of 2.5" storage devices

    Skip this step if you do not plan to use 2.5" drives.

    Connect the interface to the drive. Screw the drive to the case from the front of the case. 

    Also, if you have an SFX power supply unit, you can install another 2.5" format drive on the bottom of the case. If you have an SFX-L power supply unit, you will not be able to install the drive at the bottom. 


  6. Installing the motherboard (MP).

    The case supports MP mini-ITX format.

    Read the instructions for the motherboard. Install everything you need on it (Processor, CPU cooler, RAM, NVMe drive, if used. Follow the instructions of the component manufacturer). Install the plug in the case if it is not fixed on the motherboard before mounting the MP.
    Very carefully put the MP into the case, placing it on the racks. Screw the MP to the chassis using the screws from the DSH (Delivery set with housing) and a magnetic screwdriver. Attach the PCIe riser cable to the MP if you plan to install a video card, as well as the power button connector. 


  7. The final collection.Carefully route all cables using nylon cable ties from the DSH. Check that all cables are connected. Install the covers on the body and fasten with screws.

bottom of page