Support page for
of SLM2 6L cases
Assembling a computer requires certain knowledge and skills! This brief instruction shows the assembly sequence and is designed for the user who has already assembled computers .
Also, the case in these photos may be a little different from what you have, it happens, I make some changes in almost every batch.
-
Preparation.
Make sure your components match the case specification.
Disassemble the case by unscrewing the screws.
-
Installing the motherboard (MB).
Read the instructions for your MB. For your convenience, install everything you need on it (CPU, CPU cooler, RAM, NVMe drive, if used. Follow the instructions of the component manufacturer). Install the plug in the case, if it is not fixed on the motherboard, before mounting the MB. Connect the PCIe riser cable to the MB if you plan to install a video card. Screw the MB to the case using the screws and a magnetic screwdriver.
-
Installing the HDPlex Power Supply Unit (PSU).
Skip this step if you plan to use a 1U flex PSU.
The SLM2 6L case is compatible with the HDPlex 250, 500 GaN AIO power supplies.
Unscrew the 1U flex PSU mounting brackets and the 1U flex PSU power cable from the case; you will not need them.
The HDPlex GaN 250 power supply can be screwed to the case with or without an adapter plate.
The HDPlex GaN 500 PSU can only be installed through the adapter plate. Screw it to the PSU with screws, then screw it to the case as shown in the photo.
-
Installing the 1U flex Power Supply (PSU).
The SLM2 6L case is compatible with 1U flex PSUs up to 180mm long.
Unscrew the 1U flex PSU mounting bracket from the chassis. Screw this bracket to the PSU. Glue the plastic gasket to the PSU and remove the protective film from it. Connect the angled power cable to the PSU. Install the PSU into the chassis and screw in the mounting screws.
-
Installation of 2.5" drives.
Skip this step if you don't plan to use 2.5" drives.
Connect the interface to the drive. Unscrew the mounting plate from the housing. screw one or two drives to it. Screw the plate with drives to the case with screws.
(in the photo, the SLM1 case)
-
Video card installation.
Skip this step if you do not plan to use a video card.
Connect the additional power supply of the video card before its installation, if it is provided by the manufacturer of the video card (see the instructions for installing your video card in the video card delivery kit). Unscrew the corner for fixing the video card from the case. If necessary, change the position of the riser cable for the video card. Install the video card in the riser cable and screw it to the case.
-
Final Assembly.
Carefully route all cables using nylon cable ties. Check all cables are connected, including the power button cable. Now you can install the cover by fastening them with screws. Also screw the vertical stand.