top of page

Support Page for SX1 6.8L case

 

On this page you will find all the necessary information for assembling a computer in our case SX1 6.8L. Assembly in small cases can be difficult due to the compact arrangement of components. Our tips will help you assemble a computer quickly and correctly. Just follow our advice and recommendations. 

​

Assembling a computer requires certain knowledge and skills! If you do not have sufficient experience and knowledge in assembly, you can contact us. For buyers from Ukraine, we provide free assembly services in our buildings. We can also help with the selection of optimal components for your tasks.

17.jpg
16.jpg
13.jpg
14.jpg
11.jpg

  1.  Preparation.      Unscrew the screws on the top, bottom and back of the case using a hex screwdriver or the key from the KaPC kit supplied with the case (below). Чтобы демонтировать крышки сдвиньте их в сторону.            Make sure your components meet the specifications of the SX lm 6.8L case. Если у вас есть сомнения вы можете обратится к нам за помощью.  

  2.  Installing the motherboard. Read the instructions for your motherboard (hereafter MP). Install everything you need on it (Processor, CPU cooler, RAM, NVMe drive, if used. Follow the instructions of the component manufacturer). Install the plug in the case, if it is not fixed on the motherboard, before mounting the MP. Screw the MP to the case using the screws from the PDA and a Philips-type magnetic screwdriver. Подключите PCIe riser шлейф к МП, если планируете устанавливать Видеокарту.​         

  3. Installation of 2.5" Drive.Skip this step if you don't plan to use a 2.5" drive.Screw the PDA rubber stands to your drive. Connect the interface to the drive. Теперь можно установить накопитель в корпус.  Also, instead of a 2.5" drive, a 92x92x25mm fan can be installed in the case. It is recommended to install a grill on top of the fan to prevent the wires from getting into the fan. 

  4. Installation of the Question Block.If your PSU has a modular cable connection, connect only what is necessary. Before installing BP  in the case, you can connect the power cables to the MP. Есть два способа монтажа БП. Method 1.Dismantle the power button, insert the PSU into the case, screw it to the basket with screws using a magnetic screwdriver. Put back the power button. Подключите силовой кабель к разъему С14 на БП. Method 2.Unscrew the screws securing the bracket for the PSU, screw this bracket to the PSU. Connect the power cable to the C14 connector on the PSU, then insert the PSU with the fastener into the case and screw it into place.

  5. Video card installation. Skip this step if you do not plan to use a video card.Push the latch on the PCIe riser cable to the side as far as it will go. Connect the additional power supply of the video card, if it is provided by the manufacturer of the video card(see the instructions for installing your video card in the video card delivery kit)before its installation.You can connect the power even after installing the video card. Insert the video card into the case, install the cable in the PCIe x16 riser connector as far as it will go. Push the lock on the loop back. Прикрутите видеокарту винтами используя магнитную отвертку. 

  6. Final Assembly.Carefully lay all the cables using nylon cable ties from the PDA. Check whether all cables are connected, including the power button cable and the front USB port. If your PSU has a power button, set it to the "on" position. Install the front panel and fasten it with screws. Install the rest of the covers in any sequence and fasten them with screws.

bottom of page